Using demo PCB with reference target location mounted on machine.

Add new Part.
Move Camera to Part Location, Set part location using CX, CY
Move Head 1 to Part Location. This works OK. No problem.

BUT It does not work if ....

Either: Edit Part --> Open Feeder --> Choose Nozzle 2
Or: Pick Nozzle 2 from Nozzle Changer
Then Move Head 1 with Nozzle 2 to Part Location. This DOES NOT WORK. The machine moves Head 2 to Part Location.


Note: It works OK if

Either: Edit Part --> Open Feeder --> No Nozzle, Nozzle 1, Nozzle 3, Nozzle 4
Or: Pick Nozzle 1, Nozzle 3, Nozzle 4 from Nozzle Changer

i.e. It only fails if Nozzle 2 is chosen.

Function changed in V2.047
If nozzle changer enabled always head 1 is moved to position.
If nozzle changer disabled nozzle number in feeder setting equals to head number and corresponding head send to position.

solved since V2.048