Vision Placer - sometimes the machine stops responding

SMALLSMT Forum � Vision Placer software � Vision Placer software V2 & V1 � Vision Placer - sometimes the machine stops responding

Topic settings

Print view

Jump to forum

Forum SMALLSMT Forum Hardware questions VISION PLACER Hardware questions SMT VISOR Hardware questions HR-300 Reflow Oven Found on the internet Vision Placer software Vision Placer software V2 & V1 Vision Placer V2 Bug List Tips & Tricks DotMaker Software PnPCreator Common area SMT related questions User talk Marketplace Electronics Kendryte K210 RISC-V Controller

#1 | Vision Placer - sometimes the machine stops responding datum

Wed Aug 07, 2019 11:56 am

When using Vision Placer, sometimes the PnP machine stops responding, and no matter what I select in the program the machine is "incommunicado". Then I have to save my work, exit the program and start again.
Is there a better way?

Torfinn

reply

#2 | RE: Vision Placer - sometimes the machine stops responding datum

Wed Aug 07, 2019 2:11 pm

You need to care a good USB connection.
Hubs and long cables may produce problems!
And care about your power supply cabling to prevent voltage differences between PC ground and machine ground!

reply

V2, feed edit, change contrast and brightness, then press CX and / or CY - Brightness anc contrast gets reset � � Fiducial stategy

Related topics

Replies

Last post

Origin, Mark points and correction using vision
Created in forum Vision Placer software V2 & V1 by JohnW 6 Wed Dec 16, 2020 12:46 pm
JohnW • Views: 635
Vision Problem?
Created in forum VISION PLACER Hardware questions by hbridge 2 Mon Aug 19, 2019 3:07 am
hbridge • Views: 550
CL Feeders feed when Vision Placer Switched off
Created in forum VISION PLACER Hardware questions by Doug 1 Wed Aug 07, 2019 8:51 am
mbruch • Views: 393
Getting started with the VP-2500DP, unused machine accessories?
Created in forum VISION PLACER Hardware questions by smt_le 1 Mon Jun 17, 2019 11:01 am
mbruch • Views: 504
Problem with placement stopping permanently in the middle of a run
Created in forum Vision Placer software V2 & V1 by MtnMan 11 Thu Aug 10, 2017 7:58 am
mbruch • Views: 1369
Vision Placer Software manual updated to V1.04
Created in forum Vision Placer software V2 & V1 by mbruch 0 Wed Jan 06, 2016 9:59 pm
mbruch • Views: 673

SMALLSMT Forum

Professionelle Best�ckungsautomaten und PCB-Inspektionssysteme, Professional pick-and-place machines and PCB inspection systems

Please enter a reason for warning.