VISION PLACER Hardware questions » Vibration Feeder does not stop

SMALLSMT Forum � Hardware questions � VISION PLACER Hardware questions � Vibration Feeder does not stop

Topic settings

Jump to forum

Forum SMALLSMT Forum Hardware questions VISION PLACER Hardware questions SMT VISOR Hardware questions HR-300 Reflow Oven Found on the internet Vision Placer software Vision Placer software V2 & V1 Vision Placer V2 Bug List Tips & Tricks DotMaker Software PnPCreator Common area SMT related questions User talk Marketplace Electronics Kendryte K210 RISC-V Controller

#1 | Vibration Feeder does not stop datum

Mon Jan 20, 2020 4:57 pm

Hello,

I was setting up the vibration feeders for the SMALLSMT.BIZ V1.1. All was going fine, but after one Feeder Test the engine goes crazy and doesn't stop anymore.

Inmediately I turn off the machine, but when it start up again the vibration feeder still continue working. So I disconnect the two wire cable to interrupt the signal. I tried rebooting the computer and turning on and off the machine several times but with no effect.

Now it has a smell like something burnt, despite I left the cable disconnected. Seems like something under the machine is burnt. Do you have any idea what could be and what happened?

Also there is another problem, now I can't mount any component, the software stands Error 179.

Thanks in advance!

reply

#2 | RE: Vibration Feeder does not stop datum

Mon Jan 20, 2020 7:58 pm (Last edited: Mon Jan 20, 2020 7:59 pm)

The controller outline short against ground!
I can�t help you now still in hospital but maybe send sunny@smallsmt.biz an email first.
Machine controller power supply dc/dc converter broken.

reply