Hi Allan,
unfortunally it is not possible to move the pins down without starting the full push cycle.
The only way is to adjust one line by hand until it fits and use this position to align the next line.
You can use the top camera for alignment too.

We are planning to assist the position adjustment by moving the top camera to the first hole position so you can move the tape until it fits.

This picture shows the correct position



Best regards
Michael

Hi Allan,

yes you do just eyeball alignment by looking down the line of the holes in the tape versus the position of the push pins.
But you can inspect the tractor tape and if it got damaged you can adjust the position.
Normally each line has a constant distance so add a fixed offset from line to line.

We are building some assisting functions in software soon but need's time to finish.

Best regards
Michael